Fig. 1 — How RealShot Works

Mount it. Range it. Read it.

RealShot is a mechanical reel that clamps to your scope tube or rifle receiver. A waterproof strip, printed with your rifle's own range, elevation and wind data, slots into it. Here's what happens at each step.

01 · MOUNT IT REALSHOT REEL CLAMPS TO SCOPE TUBE OR RECEIVER

1 · Mount it

RealShot clamps to your scope tube or your rifle's receiver, so it stays with the rifle rather than in your pocket. Ring-mounted scopes use R1 (side) or R2 (low, near the receiver). Railed rifles use B1 (Weaver / Picatinny) or B2 (rimfire / air-gun dovetail).

See the four mount options →

100 200 300 400 500 600 02 · RANGE IT ROTATE TO MATCH RANGE

2 · Range it

Range your target with your rangefinder as usual, then rotate the reel until that distance lines up. Distances are printed in metres or yards, whichever you choose when you order.

ELEV WIND 03 · READ IT DIAL OR HOLD — FIRE

3 · Read it

Each row on the waterproof strip gives the range (R), the elevation (E) and the wind (W) for that distance. Dial the elevation and windage on your turrets in MOA or Mils, or use the holdover points if your strip is set up for a ballistic reticle, then take the shot.

Built around your rifle

Not a generic chart — your rifle's own numbers.

Every RealShot strip is worked out from that rifle's own bullet, load and zero, not a one-size-fits-all table. That's the whole point of the name.

Close-up of a RealShot reel showing its R, E and W data columns
A real strip: range (R), elevation (E) and wind (W), row by row.

What goes into your strip

Bullet type, weight and ballistic coefficient, muzzle velocity, zero distance, and your approximate hunting altitude — plus whether your scope dials in MOA or Mils, and whether you'd rather read metres or yards.

Reticle or turret — your choice

Set up to match standard scope turret clicks, or printed to suit a ballistic reticle's holdover marks instead — tell us which when you configure yours.

The alternative

Why not just use a phone app?

Data for this kind of shooting is usually written or printed on paper or card — sometimes taped straight to the butt of the rifle. It gets lost, forgotten, or destroyed. Phones are slow to use, and no faster if you have to get up or move to check one.

Phone ballistic appRealShot
Battery / signalNeeds bothNeeds neither
Cold, wet handsFumbly, screen glareOne twist, read it
Where it livesIn your pocket — if you remember itOn the rifle, always
Speed at the moment of truthUnlock, open app, waitGlance, dial, fire

Which mount fits your rifle?

Four options cover scope rings, Picatinny/Weaver rails and rimfire or air-gun dovetails.

Choose your mount